6. Adjust the Operating Glass Panel
The operating glass panel can be horizontally adjusted up to 3" (7.6 cm) to fit the shower opening.
To Adjust Panel
Using the 5/32" hex key provided, loosen the screws located in both the top and bottom hinges.
Adjust the panel position by carefully sliding the panel back and forth - position approximately 1"
(2.5 cm) from the strike jamb side of wall.
NOTE: Allow room for the strike jamb installation (refer to "Install the Strike Jamb and Strike Jamb Cap"
section).
Kohler Co.
5/32" Hex Key
Adjust glass panel position by sliding back
and forth – position approximately 1" (2.5 cm)
from strike jamb side of wall.
Hinge
Screws
9
1011451-2-H