Important Safeguards; Name And Functions Of Buttons; Initial Setup And Battery Replacement - D-Mail 315540 Manual Del Usuario

IMPORTANT SAFEGUARDS

To prevent any injury, follow these instructions strictly and keep the manual for future reference. The manufacturer
declines every responsibility in case of misuses of the product.
• Adult Assemblebly required:
• Keep all parts out of the reach of children
• Read this manual before assembling or using this product.
• Check product for loose or broken parts before each use.
• Discontinue use when any missing, broken, and loosen parts.
• The maximum weight limit of this measuring cup scale is 3 kg.
• For home use only.

NAME AND FUNCTIONS OF BUTTONS

Button Press Functions
Turn on the unit
0 (zero)
Tare or reserve tare
m (mode) Change the display mode
u (unit)
Select display unit
The transparent cup is detachable for cleaning. Press the button below the handle to unlock and detach the cup from
the base. For normal operation, attach the cup to the base.
IMPORTANT: To reset, remove the batteries

INITIAL SETUP AND BATTERY REPLACEMENT

Initial Setup
• Make sure the transparent cup is attached to the base
• The unit comes with a battery. For fi rst installation, pull out the insulation sheet from the battery door to turn on the
unit.
• Right after the unit is powered on, place the empty cup scale on a fl at table and it should read 0 (gram, or Cups). (Go
to "calibration" section to calibrate the cup if the reading is higher than 0)
Battery replacement
Slide down the battery door to open. Replace 1 piece of CR2450 battery according to the polarity indicated and close
the battery door.
Power On/Off
Make sure the cup is attached to the base. Place the cup scale on a fl at surface and press the [0] button to turn on the unit.
• To ensure accurate measurement, you are suggested to check the weight of an empty cup every time you fi rst turn
on the unit. It should read 0 gram (or oz) for your empty cup. If not, please calibrate the cup following the instruc-
tion in the "CALIBRATION" section.
Hold 3 seconds
Turn off the unit
7
Hold 6 seconds
When the unit is on, hold 6 sec
to calibrate an empty cup