Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! TO PREVENT SHOCK OR FIRE HAZARD DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE. DO NOT REMOVE FROM CASE. NO USER SERVICEABLE
PARTS INSIDE. REFER ALL SERVICING TO QUALIFIED SERVICE PERSONNEL.
REPLACE FUSE ONLY WITH ONE OF THE SAME TYPE AND SPECIFICATION.
Thank you for choosing Peavey's Eurosys 15PM powered monitor enclosure as part of your sound
reinforcement system. We take great pride in the design and manufacture of our units and you can expect
top performance and reliability. Your Eurosys 15PM has been rigorously tested before packing and
despatch to your dealer. It has been designed to run from a nominal 230 Volt AC mains supply.
1. AMPLIFIER INPUTS
Use to connect line level signals from the monitor send of the mixer. Two sockets are provided to
allow connection to further Eurosys 15PM powered monitors. (Daisy chaining).
2. VOLUME
This slider controls the level or volume of the enclosure.
3. 4 BAND GRAPHIC EQUALISER
Four sliders allowing up to +/- 12dB of adjustment at the centre frequencies of: - 100Hz , 1KHz ,
5KHz and 10KHz. Use to assist with any feedback problems.
4.
~ PILOT LIGHT
Illuminates when AC mains power is being supplied to the amplifier.
5. EXTENSION SPEAKER SOCKET
Allows connection of a further unpowered monitor with an impedance of 8 ohms. The power amplifier
will develop full power into 4 ohms. (150 Watts).
6. POWER SWITCH
Use to turn the Eurosys 15PM ON or OFF
7. MAINS CONNECTOR & FUSE HOLDER
An IEC 320 combined mains connector and fuse holder is fitted. A separate 3-wire mains cord fitted
with a moulded plug is supplied.
8. 13 AMP PLUG REPLACEMENT
As the colours of the wires in the mains lead or cord of this apparatus may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
- the wire which is coloured green and yellow must be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol, or coloured green or green yellow.
- the wire which is coloured blue must be connected to the terminal which is marked with the letter N
or coloured black.
- the wire which is coloured brown must be connected to the terminal which is marked with the letter
L or coloured red.
WARNING - THIS APPARATUS MUST BE EARTHED
SPECIFICATIONS
POWER OUTPUT (TYPICALLY)
105 Watts into 8 ohms
150 Watts into 4 ohms
INPUT SENSITIVITY
0.7 volt for 105 Watts into 8 ohms
FUSE RATING
1.6 ampere anti surge.
IN CASE OF DIFFICULTY CONSULT YOUR AUTHORISED PEAVEY DEALER
Due to our efforts for constant improvement, features and specifications are subject to change
without notice.
EuroSys 15PM
Powered Monitor Enclosure
OPERATING INSTRUCTIONS
POWER REQUIREMENTS
325 Watts at 150 Watts output
MAINS VOLTAGE REQUIREMENTS
230 Volts AC (only) 50/60 Hz
Publicidad
