Helpful Hints; Changing Modes; Taking A Reading - Person - MABIS Healthcare RediScan 18-535-000 Instrucciones

Helpful Hints

• For accurate results, wait at least 30 minutes after exercising, bathing or
returning from the outdoors.
• Wait at least 1 minute between readings.
• If multiple readings are taken over a short period of time, use the
average of those readings.
• Because everyone's temperature varies slightly, keep a record of your
body temperature to serve as a reference when judging a fever.

Changing Modes

Switching Between Person or Object
First determine whether you want to
measure the temperature of a person or
an object.
1. Press the (Power) button to turn on
the thermometer.
person or an object, press the 'Mode' button, Fig. 1.
2. To switch between the measurement modes for a
symbol appears to measure an object, Fig. 2.
The symbol appears to measure a person and the
Switching Between Fahrenheit or Celsius
1. Press the 'Power' button to turn the thermometer on.
2. Press and hold both the 'Mode' and 'Memory' buttons for
either °C or °F, Fig. 3. Once the thermometer beeps, the
approximately 3 seconds. This will change the mode to
unit is ready for measurement.
NOTE: To switch the mode again, wait until the unit beeps
and then press and hold both the 'Mode' and 'Memory'
buttons until the mode switches to either °C or °F.
Mode Button
Memory Button
Fig. 1
Fig. 2
Fig. 3
8

Taking a Reading - Person

Taking the Temperature of a Person:
NOTE: Be sure the thermometer is set to measure the
temperature of a person.
1. If the thermometer is off, press the 'Power' button
to turn the thermometer on.
appear like Fig. 4.
2. Press and hold the 'SCAN' button. The screen should
forehead, Fig.5. Hold the thermometer
3. Aim the front of the thermometer at the person's
approximately 2" to 3" away from the
forehead.
NOTE: Attempting to take a measurement
anywhere else on the body may result in an
inaccurate reading.
4. While continuing to press the 'SCAN'
button, slowly move the thermometer
toward or away from their forehead
until the thermometer is
LED light flashes, Fig. 6.
continuously beeping and the
5. The 'beeping' indicates that the
distance required for the
measurement is correct. Once the
thermometer is consistently and
continuously beeping, release the
'SCAN' button.
Fig. 4
Fig. 5
Fig. 6
9