Velleman-Kit K8057 Manual Del Usuario página 8

Instructions
4. 'SELECT' (LD3) and 'CONFIRM' (LD4) start flashing.
5. Release 'setup' when leds turn off.

This process takes about 10 seconds.

If the button is released before the leds turn off, the memory will not be cleared.

The unit will now respond to the default code only.
Configuration of CH1 and CH2 :
1. Push 'setup'-button repeatedly to select CH1 (left) or CH2 (right) configuration.
2. Confirm with a long push ('CONFIRM' flashes 3 times (LD4)).
The selected relay will remain ON.
3. Push 'setup'-button a number of times, depending on the desired mode (see table).
At each press, 'SELECT' (LD3) will flash a number of times, indicating the current mode.

The unit returns to normal operation when left idle for 10s.
4. Confirm with a long push ('CONFIRM' flashes 3 times (LD4)).
The selected channel will turn off and the unit is ready for use.
If necessary, repeat sequence for the remaining channel.
8
flashes
Factory defaults : CH1 : 1htimer, CH2 : 0,5s timer
Mode
1 ON/OFF
2 0.5s timer
3 5s timer
4 30s timer
5 1min timer
6 5min timer
7 15min timer
8 30min timer
9 1h timer