Trimmer Guide - Ingersoll Rand CD-EU Serie Instrucciones

CHANGING THE ROUTER BIT
To change a Router Bit, proceed as follows:
1. Using a 5/64" hex wrench, loosen the Adapter Lock
Screw. Unscrew and remove the assembled Nosepiece
Adapter.
2. Insert the Sprag Pin into the hole in the side of the
Motor Clamp Nut and rotate the Collet Nut until the
Pin sprags the flat on the Collet Body.
PART NUMBER FOR ORDERING
R120–128–2 (for 1/4" shank)
R120–128–7 (for 1/4" shank)
K Note: Offset = 1/2 ("B" dimension minus trimmer bit diameter.)
The following equipment is available at an extra price and must be ordered separately:
1. Router Attachment Assembly
for models using 1/4" diameter bits
2. Trimmer Guide (for Router Attachments)
for 1/4" shank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
for 1/4" shank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PLACING TOOL IN SERVICE

TRIMMER GUIDE

Trimmer Guide Dimensions
A
1–1/2
2–1/2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
3. Using one of the Collet wrenches, loosen the Collet
Nut. Remove the router bit and insert the new bit into
the Collet. Tighten the Collet Nut.
4. Remove the Sprag Pin and install the assembled
Nosepiece Adapter over the bit and thread it onto the
Motor Clamp Nut. Tighten the Adapter between 2 and
3 ft–lb (2.7 and 4.0 Nm) torque.
5. Using a 5/64" hex wrench, tighten Adapter Lock Screw
between 12 and 18 in–lb (1.3 and 2.0 Nm) torque.
OFFSET
B C
3/8 3/8
1/2 1/2
(Dwg. TPD1208)
D E
1/8 1/2–20NF
3/16 1/2–20NF
Part No. CD–RK4
Part No. R120–128–2
Part No. R120–128–7