Battery Disposal - EURO-PRO EP750 Instrucciones Para El Uso Y Cuidado

CHARGING THE CORDLESS VACUUM
1. Connect the charger plug to the charging hole on the back of the vacuum
cleaner. (See fig. 1) Plug the the charging transformer into the wall outlet.
2. This vacuum cleaner is powered by Ni-Cd batteries. Before first use,
they must be charged for a minimum of 16 hours.
3. Once the batteries are fully charged, the vacuum cleaner will run for
approximately 20 minutes before recharging is required.
4. When recharging the unit, the On/Off switch must be in the OFF position.
5. To recharge, repeat step #1 above. Charging times will vary depending upon
the amount of usage between charging cycles.
6. The charging light indicator (5) on the top of the vacuum will illuminate to
indicate that the vacuum is properly charging.
NOTE: Peak performance may only be realized after the
unit has been charged and discharged two (2) or
three (3) times.
IMPORTANT: To maintain peak performance of your
cordless hand vacuum, it is recommended
that the unit be fully discharged, then
completely re-charged at least once a month.
Battery Compartment
Cover Screw
Fig. 1
5
BATTERY PACK REPLACEMENT
NOTE: If uncertain as to how to change your battery pack,
we suggest you take your vacuum to a reputable
small appliance service technician to have this
service performed.
This vacuum cleaner is equipped with Ni-Cd batteries and you need to dispose of
them properly. When the batteries are no longer good for use, they must be
removed from the vacuum cleaner for disposal. Do not remove the batteries for any
reason other than disposal of them.
The battery pack of your EP750 Is replaceable, however care should be taken when
doing so. Follow these steps when replacement is required:
1. Open the battery compartment, by removing the single, Phillips head screw
located in the recess at the rear of the unit. NEVER open battery compartment
except to change the battery when required.
2. Remove battery compartment cover. Set aside battery compartment cover
and screw.
3. Carefully detach the two (2) electrical connectors from the battery pack by
pulling straight away from the battery.
4. Lift out old battery pack and set aside.
5. Insert new battery pack in battery compartment and re-connect terminals by
pushing lead wires onto battery tabs.
6. Tuck wiring inside battery compartment so that the wiring does not interfere
with the battery compartment cover when it is replaced.
7. Re-install the battery compartment cover by sliding it over the battery toward
the front of the unit, making sure that the front snap engages the body of the
unit.
8. Replace the battery compartment cover screw.
• Use only with the battery pack supplied with the unit.
• Do not attempt to remove the battery pack from the unit to charge it.
• Never attempt to throw the battery pack or unit into a fire or incinerate it.
• Do not attempt to remove or damage the battery casing.
• Battery must be recycled or disposed of properly at the end of it's
service life.
WARNING:
NEVER use ordinary batteries for replacement, as these
may leak and damage your vacuum cleaner.
CAUTION:
NEVER use the unit without the battery compartment cover
in place.

BATTERY DISPOSAL

This vacuum cleaner contains a nickel-cadmium (Ni-Cd) batteries and must
be disposed of properly. Call your nearest recycling center for information
on the recycling and disposal of nickel-cadmium (Ni-Cd) batteries
CAUTION
6