Versions - GMV ETC Serie Instrucciones Originales

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENG
8 / 12
LED LIGHTS IN THE WORKING PHASE
The ETC System has 3 leds:
-
the led n.13, green for Upward
-
the led n.14, yellow to check the device status
-
the led n.15, green for Downward
D
EVICE POWERING ON
-
the green led n.15 (downward), quickly flashes for few seconds.
-
As a first test, the system checks the temperature is between 15°C – 50°C,
-
In case the temperature does not match the range, the led n.14 yellow led
blinks The lift could start running regularly.
-
Once the temperature reaches the range limit, the device checks that
there are no signals (up, down, error) and starts tuning the values if
necessary.
W
.
ORKING ERRORS
Up and Down signals (leds 13 and 15) flash simultaneously
Up or Down signals are off when when high speed signals is on
Levelling phase too short
Travel time too short
Any abnormal working, put in error the ETC card and the yellow led n.14 starts
blinking to the next trave.
At the floor, the yellow led n.14 is on.The remaining leds stay off. At the start, the
device clears the timer of the high speed travel. It turns into a listening mode to
aquire the low speed signal.In the high speed phase the green led n.13 in on
and n.15 flashes. There is any tuning if the high speed time travel is less than
3,5 seconds.
Otherwise: The device adjusts the FLY-time at the measured temperature,
according to the pre-set time delay [s] and the pre-set time delay percent [%], set
via the dip-switches.
D
D
IRECTION
IPSWITCH
Up travel
Down travel
At the end of the delay calculation, the yellow led turns on and the "in-travel" leds n.13 or 15 turn in fixed
mode.
In the landing phase (without any signals) the yellow error led n.14 turns in fixed mode and the green "in-
travel" leds n.13 and 15 stay off.

1.3 VERSIONS

There are different versions of ETC device
• Version AC
cod. 70205637 to connect coils from 80 to 240 Volt
• Version DC
cod. 70205638 to connect coils from 40 to 60 Volt
cod. 70205693 to connect coils from 80 to 180 Volt
10991802 EN - 1.02 - 20.02.2019
ETC S
,
INSTALLATION
USE AND MAINTENANCE MANUAL
:
OFF
1
long [s]
2
less [%]
3
long [s]
4
less [%]
YSTEM
ON
short [s]
more [%]
short [s]
more [%]
;
AC
;
DC
.
DC

Publicidad

Tabla de contenido
loading

Tabla de contenido