Pfister HanoveR 531 Serie Manual De Instrucciones página 4

11
11C
11D
11C
11A
11D
11E
11B
11 WATER SUPPLY CONNECTIONS
First, thread Inlet Connectors (11A) into Water Supply Lines (11B). Then, insert Inlet
Connectors (11A) into Valve Bodies (11C). Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer's instructions when installing supply lines. Next, insert Clips (11D) into
Valve Body Holes (11E), to secure unit.
WARNING: Do not twist Inlet Connectors (11A) once installed!
12
12C
12C
12A
12D
12A
12A
12 PULL-OUT HOSE ATTACHMENT
From underneath sink, push Quick Connector (12A), located on the end of the Pull-Out
Hose (12B) firmly upward onto the Receiving Tube (12C), until unable to push any further.
Pull down on the Quick Connector (12A). If the housing and the Inner Collet (12D)
separate slightly but do not pull off, the Receiving Tube (12C), quick connect is secure.
To remove Pull-Out Hose (12B), Push up on Quick Connector (12A). Holding Plastic
Collet (12D) in place, pull downward on Quick Connector (12A) until Tube (12C) is free.
13 WEIGHT ATTACHMENT
11C
11A
HOT
11B
COLD
12B
12A
ENGLISH
13
13B
13D
Discard Cardboard Fitting (13B) from Weight (13A). Place Weight (13A) above the
beginning of hose bend (13C) at the spout side (as shown in shaded area). Secure
Weight (13A) with Screws (13D).
14 SOAP DISPENSER INSTALLATION
14
12D
From above sink, insert threaded Shank (14A) of soap dispenser body through Foam
Gasket (14B) and sink hole. From below sink, tighten Nut (14C) and thread on Bottle
(14D) to Shank (14A).
15 SOAP DISPENSER HEAD INSTALLATION
4
13A
13C
14A
14B
14C
14D