Axxess GMOS-MOST-01 Guia De Instalacion página 4

ASWC-1 wiring:
If installing an ASWC-1 (sold separately), refer to the following instructions for wiring.
• Connect the Black wire to chassis ground.
• Connect the Red wire to accessory power.
• Connect the Pink wire, to the Green/Black wire in the 8-pin black connector located in the
steering column. (Figure A)
• For the radios listed below: Connect the 3.5mm adapter priovided with the ASWC-1, to the
male 3.5mm jack from the ASWC-1. Any remaining wires tape off and disregard.
• Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White
wire of the connector. Then connect the remaining steering wheel control wire, normally
Brown/White, to the Brown wire of the connector.
• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire
to the Brown wire.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack to the AX-SWC-PARROT (sold
separately), then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
• Universal "2 or 3 wire" radio: a) Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining steering
wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire of the
connector. If the radio comes with a third wire for ground, disregard this wire.
Note: After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.
4
CONNECTIONS
(CONT)
• For all other radios: Connect the 3.5mm jack into the jack on the aftermarket radio
designated for an external steering wheel control interface. Refer to the manual provided
with the aftermarket radio if in doubt as to where the 3.5mm jack goes to.
(Figure A)
Green/Black wire