Dometic Premium Markise DA20DC Instrucciones De Montaje página 20

Installing the awning
NOTE
I
The recommended mounting position for each counter plate is
shown in fig. 8 A,page 1.
If any objects are obstructing this mounting position for the counter
plates, you can mount the counter plates as shown in
fig. 8 B,page 1:
 Choose a drill hole from the four drill hole pairs.
 Fasten each counter plate with four screws.
➤ Align the mounting bracket on the vehicle and mark where the holes are
to be drilled (fig. 8, page 1).
➤ At the marked points, drill holes with a diameter of 11 mm from the outside
through the external wall (fig. 9, page 1).
➤ Shorten the spacer sleeves to the size A = wall thickness W – 2 mm
(fig. 0, page 1).
➤ Insert the spacing sleeves into the holes from the outside.
➤ Trim the fastening screws to size B = wall thickness W + 14 mm (fig. 0,
page 1).
NOTICE!
A
Observe the sealant manufacturer's instructions.
➤ Clean the adherends on the mounting bracket and the wall.
➤ Prepare the adherends with the primer.
➤ To glue and seal apply an elastic adhesive, such as Sikaflex
example, to the back of the mounting bracket (fig. a, page 2).
Ensure to seal the holes properly to avoid moisture in the RV wall.
➤ Lift the mounting bracket to the wall (fig. b, page 2).
➤ Install the mounting brackets with backer plates, fastening screws, spacer
sleeves, washers, holder rings and nuts (fig. c, page 2).
Tighten the bolts to 5 – 9 Nm.
➤ Wait until the glue has set. For further details, please refer to the
information provided by the sealant manufacturer.
➤ Use a screwdriver to loosen the two tabs on the right-hand cap cover
(fig. d, page 2) and remove the cap cover.
18
DA20DC
®
-252 for
EN