Pressing The Buttons - Tiiwee A2 Manual De Instrucciones

First preparation of the A2 PIR Motion Sensor Alarm
Slide off the back lid, and insert 3 AAA batteries. Close the lid. Your system should be armed and ready for use.

Pressing the buttons

IMPORTANT: There are 2 ways to press the buttons on your Alarm unit:
•
Short press: press the button for 1 second or less.
•
Long press: keep the button pressed for 5 seconds.
Usually, the long press of 5 seconds is used to enter a programming or pairing mode. This procedure
prevents that important settings are changed accidentally.
Using the A2 PIR motion Sensor Alarm
The A2 PIR Motion Sensor Alarm can be operated both through the remote control as well as by pressing the
buttons on the top.
IMPORTANT: Please note that switching the unit On/ Off and arming it are two individual steps. Switching it
on does NOT automatically mean that the unit is armed and active because The PIR motion sensor alarm is
equipped with a memory function which allows the unit to resume in its last setting after switching off. If
that setting was 'armed' it will come back to that setting. If the setting was 'disarmed', it will be disarmed at
startup.
Switch the unit ON for the first time:
Long press the On/Off button [
on the front will light up once. This means the unit is now switched on. The factory settings are as such that the
PIR motion sensor alarm will startup in armed mode.
Disarming the PIR motion sensor: Press the On/Off button [
detector light will light two times. Your PIR motion sensor alarm is now disarmed. Alternatively, press the
Disarm button on the remote control.
Arming the PIR motion sensor: Press the On/Off button [
light will light up once. Your PIR motion sensor alarm is now armed. Alternatively, press the Arm button on the
remote control
Changing the sound: Short press the Mode button
pressed, a short sample of the chosen sound is heard (Siren or Chime).
Stopping the Siren alarm sound: There are three ways to stop the siren alarm sound:
1. Short press the Mode button
stay armed.
2. Short press the On/Off button [
will stop. The PIR motion sensor alarm is now disarmed. Short press the On/Off button [
again.
3. Press the Arm or Disarm button on the remote control. In case of pressing the Arm button the alarm stops
and the unit stays armed. When pressing the Disarm button the alarm stops and the unit changes in the
disarmed mode at the same time.
Switching the unit OFF: Long press the On/Off button [
the red detection light on the front will light up once.
] on the Alarm Unit. There will be one short beep and the red detection light
【
【 】
or the Pairing button
] on the Alarm Unit. There will be two short beeps and the alarm sound
] shortly. You will hear two beeps and the
] shortly. You will hear one beep and the detector
】
to change between sounds. Each time the button is
【 】
. The sound will stop and the unit will
] on the Alarm Unit. There will be one long beep and
] again to arm it