Tiiwee A2 Manual De Instrucciones página 4

Using the remote control
The supplied remote control will work with multiple PIR motion sensor alarms if required. Each new PIR motion
sensor alarm is supplied with a remote pre-paired with your PIR motion sensor.
There are four buttons on the remote control:
Button
Arm button (F)
Disarm button (G)
Switch Voice button (H) Change siren type
Bell Button (I)
Deleting remote controls and sensors from the A2 PIR Motion Sensor Alarm
1. Enter pairing mode by long pressing the Pairing button
On. The detection light is now on.
2. Now, again long press the Pairing button
remote control (and, if applicable, added sensors) have now been disconnected from your PIR motion
sensor.
3. Press the Pairing button
IMPORTANT: If you have added emergency sensors, then these can only be deleted from the device by doing
a factory reset. Please refer to the corresponding instructions in this manual.
Changing the batteries
IMPORTANT: When the batteries are running empty the detector light will flash once every 40 seconds and a
beeping sound will be heard. Please change the batteries at your earliest convenience.
Remote control
The battery can be changed by removing the screw on the back of the remote control. Remove the back panel
and replace the battery. The battery type is CR2032 (3V, Lithium battery).
PIR motion sensor alarm
Slide off the back panel and replace the batteries with 3x AAA size 1.5V Alkaline batteries.
Reset to Factory settings
Follow this procedure to reset the PIR motion sensor alarm back to the factory settings and disconnect any
remote controls and emergency sensors.
- Make sure the device is switched On.
- Remove one or all the batteries.
- Press the Mode button
Re-insert the battery
o
10 beeps will be heard and then another 5 beeps very quickly
o
- Now, release the Pairing button
- The factory reset is now completed.
Your PIR motion sensor alarm is reset and will resume in Armed mode.
Action
Switch On
Switch Off
Alarm will sound
【
【 】
to exit the settings mode.
【 】
and keep it pressed throughout the next 2 events:
【 】
What happens if pressed
PIR motion sensor alarm is activated
PIR motion sensor alarm is deactivated
Siren changes from chime to siren or vice versa
Siren sounds loud. Press Disarm button to stop.
【 】
when the PIR motion sensor alarm is
】
5 Beeps will be heard and the light will flash. Your