Product Dimensions; Installation Instructions - Danze Ziga Zaga DC037341 Instrucciones Para La Instalación

Product dImensIons

21 "
1/8
13 "
3/4
11 "
1/8
20 "
1/4
17"
18 "
1/2
" HOT
3/8
8 "

InstallatIon InstructIons

For installation on the Ziga Zaga™ or other bathroom vanities
3
3 "
1/4
5 "
1/8
9 "
1/2
16 "
3/4
"
7/8
6 "
5/8
" COLD
3/8
1 " WASTE
1/4
FINISHED FLOOR
1. Install the Ziga Zaga™ or other bathroom van-
ity according to the Installation Instructions pro-
vided with the bathroom vanity.
2. Use a level to assure that the slab or counter
top is perfectly flat in length and width.
3. Use a pencil to lightly mark the centerlines for
location of the lavatory (A) on the slab or counter
top.
6 "
5/8
4. Cut out template (Z) at dashed line. Line up
the centerline arrows on the template (Z) with the
centerlines marked on the slab or counter top.
Trace around the outside of the template (Z).
This line indicates where the outer edge of the
lavatory (A) will be after installation.
5. Cut off the outer rim of the template (Z) at
the solid line. Center the template (Z) inside the
marked line and trace the cutting line on the slab
or counter top.
6. Cut opening in slab or counter top on the
inside line.
7. Assemble faucet and drain (not included) in
lavatory (A) according to the manufacturer's rec-
ommendations.
8. Apply two continuous beads of adhesive
caulk (not included) between the opening in the
slab or counter top and the marked line. Spread
adhesive caulk slightly with a putty knife or
other flat tool.
9. Set the lavatory (A) into the proper position
in the slab or counter top, using the outside line
as a guide.
4