Maintenance; Use Recommendations; Troubleshooting - CUISIMAT ZUMMO ZUMMITO Z 05 Guia Del Usuario

10

MAINTENANCE

The only maintenance that the machine requires is to periodically lubricate the paddle shaft.
(Fig. 18). Always use grease approved for use with food products.
11

USE RECOMMENDATIONS

• Make sure you are using the right squeezing parts (Balls & Cups) for the size of fruit you
wish to squeeze. If the fruit to squeeze is too big or too small for the squeezing kit used, the
quality of the juice may decrease, getting a bitter juice flavour.
• We recommend to switch off the machine when is not going to be use. (Fig. 6)
12

TROUBLESHOOTING

Problem Cause and/or solution
The display does Lack of electrical current.
not become lit Fuse burnt out. (Fig. 11-1)
Power cable improperly connected.
Turn on the power switch. Fig. 6
Humidity in electronic plate. Provide dry heat to the plate.
StoP appears on Cover not properly in place. (Figs. 8 & 9)
Tray that holds squeezers out of place. (Fig.10)
the display
The letter A Check to see if frozen oranges are being squeezed.
Check if peelings have piled up on the tray that holds squeezers.
appears blinking on
Check to see if balls have been left un-tightened.
the display
Check to see if peelings are left stuck to the inside of cups.
To unblock the machine, use an Allen key of 5mm which you will find at
the right side of the grid. Introduce it in the right side lateral hole
(Fig.21) and, with the machine switched off, turn the key clockwise till
cups are up and the machine is unblocked.
LOOK OUT: before switching the machine, make sure that the key is
out of the anchorage.
The cups break Nuts on the cups are improperly tightened.
Excess of washers under the balls.
The balls on the tray that holds squeezers are loose.
The blade is not properly positioned.
Do not place green cups with large red balls (Ø82).
Oranges are either too small or too large for the cups.
Blade breakage The blade has been placed over its shaft.
The Balls are loose.
The balls break
The nuts on the cups are improperly tightened.
More than two washers have been placed under each ball.
Washers are missing under balls.
Oranges are not
thoroughly Orange peels are too thin; place a maximum of one washer under balls.
squeezed
Oranges dash out The paddle shaft is too dry; proceed to grease it. (Fig. 18)
from the paddle
The process that must follow to modify the STOP point
The machine does
not stop with cups from the electronic plate is the following one:
- To disconnect the machine by means of the back switch.
in vertical position.
- To connect again simultaneously that STOP is pressed. four numbers
will appear in the screen.
17