Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
wARNING MESSAGE TO INSTALLERS AND MAINTENANCE PERSONNEL OF HORN-
People's lives depend on your safe installation of our products. It is important to follow all instruc-
tions shipped with the products. This device is to be installed by a trained electrician who is thor-
oughly familiar with the National Electrical Code and will follow the NEC Guidelines as well as
local codes.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the Facilities Engineer and the Safety Engineer. In addition,
listed below are some other important safety instructions and precautions you should follow:
•
Read and understand all instructions before installing or operating this equipment.
•
Failure to follow all safety precautions and instructions may result in property damage or seri-
ous injury to you or others.
•
This unit should be installed by a qualified electrician in accordance with local electrical and
fire codes.
•
If the unit is not installed in a supervisory system, it must be tested at regular intervals. Refer to
local fire codes for this information.
•
After installation, test the light system to ensure that it is operating properly.
•
After testing is complete, provide a copy of this instruction sheet to all operating and servicing
personnel.
•
Disconnect power before any installations are made.
•
Establish a procedure to routinely check the light system for proper activation and operation.
•
Any maintenance to the light system must be performed by a trained electrician in accordance
with NEC Guidelines and local codes.
•
The nameplate, which may contain cautionary or other information of importance to mainte-
nance personnel, should NOT be obscured in any way. Ensure that the nameplate remains read-
able when the housing's exterior is painted.
INSTALLATION INSTRUCTIONS FOR STROBE LIGHT ON HORNS AND SPEAKERS
A. Introduction.
This sheet provides the user with instructions for the installation of Strobe Warning Lights on
horns and speakers. All instructions assume that mounting provisions have been completed and
electrical power has been routed to the installation site.
The warning light can be weatherproofed by installing the supplied gasket (refer to paragraph
E). Also the audible signal or adapter plate should be weatherproofed by using the proper elec-
trical box.
High voltages may be present inside the light assembly even though power is not connected.
If access to the component board is required (removal or replacement), the capacitor must be
discharged by touching a wire to both ends of the strobe tube. Do not attempt to touch or
LIGHT SYSTEMS
move the assembly until the capacitor has been discharged.
wARNING
-1-
MESSAGE
Publicidad
