Pre-Operation Check; Operation - Jacobsen RYAN JR. SODCUTTER Serie Manual De Servicio Y Piezas

Jr.
Sodcutter

PRE-OPERATION CHECK

1. Visually check all moving parts and all fasteners.
If loose or broken, tighten or replace. Check belt
for fraying, wear and proper adjustment (see
SERVICE section).
2. Lubricate all lubrication fittings before each days
use or after every eight hours of operation (see
SERVICE section).
3. Check the engine crankcase oil level with the
engine resting in a level position. Add oil if
necessary.
4. Check the gear case oil level. Add oil if
necessary.
5. Check the air filter. Replace if necessary.
6. Sharpen cutting blade (see SERVICE section).
7. Follow the engine manufacturer's
recommendations for the correct type and
amount of oil. Fill the fuel tank according to the
engine manufacturer's specifications.
Gasoline is extremely flammable and highly
explosive under certain conditions. Always stop
the engine and do not smoke or allow open
flames or sparks when refueling. BE SURE to
install fuel cap after refueling.
Do not fill containers in a vehicle or on a truck or
trailer bed with a plastic liner. Fill containers on
the ground away from the vehicle.
Refuel equipment on the ground. If equipment
must be fueled on a truck or trailer, refuel from a
portable container rather than a dispenser
nozzle.
Keep the dispenser nozzle in contact with the
rim of the fuel tank or container opening until
fueling is complete. Do not use a nozzle lock-
open device.
NEVER start or run the engine inside where
exhaust fumes can collect. Carbon monoxide
present in the exhaust is an odorless and deadly
gas.
DO NOT operate equipment without shields in
place. DO NOT make adjustments or perform
any maintenance while the engine is running.
Before operating, check the area and remove
any object which may present a safety hazard or
damage the equipment.

OPERATION

GB-7