Select Cycle; Pull Control Dial Out To Start - Maytag LAV-3 Guía De Uso Y Cuidado

Using the Controls
STEP 5

Select Cycle

To select a cycle, push the control dial IN and turn it to
the right (clockwise) until the pointer is at the number
of minutes desired for the wash load.
Regular Cycle
For regular fabrics, select the cycle time and turn the
Wash/Spin Speed dial to Regular/Fast/Fast. For
maximum cleaning set the dial at 16.
Note
• The spin speed will always be Fast on Regular
cycle settings.
Permanent Press Cycle
This cycle provides up to 10 minutes of agitation.
Depending on the load, select either the Regular/Fast/Fast
or Perm. Press/Fast/Slow wash spin speed.
Gentle Cycle
The Gentle Cycle provides approximately 10 minutes of
agitation and soaking to help remove stains.
Soak Only
There will be a brief period of agitation followed by a
soak. Soaking should be no longer than 30 minutes.
The control dial must be advanced manually to a spin
or a wash setting.
STEP 6

Pull Control Dial Out to Start

You may stop the washer at any time by simply
pushing the control dial IN. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed IN (off position) when you change the setting.
Control features vary by model.
Note
• Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
6