HMM Diagnostics smartLAB mini Manual Del Usuario página 49

4. Blood glucose measurement
Hold the application zone of the test strip vertically onto the blood
sample. The blood is automatically sucked in the reaction zone of
the test strip. Be sure to get enough blood on the strip's reaction
zone, otherwise, an inaccurate reading may result. The signal tone
indicates that enough blood entered the reaction zone. The meter
will now start with the measurement which will last 5 seconds. The
LCD display shows the remaining time of measurement in seconds.
Afterwards the note „OK" indicates a correct measurement. The
measurement is finished with another signal beep and the meas-
ured value is shown on the display.
5. Storing memories
The displayed result is automatically stored in the memory of the
meter. If more than 20 results are reached, the oldest one is de-
leted.
6. Discarding used test strips and lancets
Write down the measured result in your personal diabetic log book
and take the test strip off the strip slot. The meter turns off. If you
don't take off the test strip, the meter will turn off automatically
after 5 minutes.
In order to discard lancets from the smartLAB
lancing device, re-
®
move the end cap and carefully pull the used lancet out of the hol-
der. Dispose of the lancet of according to local regulations.
18