Adjusting The Volume - I.SOUND DuraWaves Guía De Usuario

connected via AUX, your phone will act as the microphone and
you will hear your caller through the DuraWaves speaker.
1. When a phone call comes in, answer it as you normally would
on your phone, or press the hands- ee bu on on DuraWaves.
2. Your caller's voice will play through DuraWaves.
3. When your call is over, hang up as you normally would on
your phone or press the hands- ee bu on.
Connecting via audio cable
1. Make sure DuraWaves is charged.
2. Turn DuraWaves on by sliding the power switch at the top le .
3. Connect one end of the included 3.5mm audio cable to the
"AUX IN" port on the back of the unit. Connect the other end
to the 3.5mm headphone jack of your audio device.
NOTE: Connecting the audio cable will override Bluetooth
mode. DuraWaves will automatically switch to auxiliary when
the audio cable is connected.
4. Make sure the volume of your audio device and the volume
of DuraWaves are both set to medium/low.
5. Play music on your device and slowly adjust the volume to
the desired level.

Adjusting the volume

You can adjust the volume on your Bluetooth-enabled device
and on DuraWaves.
Using the suction cup
1. Clean the glossy back surface of DuraWaves with a dry cloth.
2. Make sure both the speaker surface and suction cup are ee
of dirt, dust and debris.
3. Firmly stick the side of the suction cup without the pull tab