Troy-Bilt FLEX 23AACAAX711 Manual Del Operador página 12

5. Pivot the mounting frame bracket down, as shown in
Figure 5-4.
6. Remove the belt from the drive pulley assembly, as shown
in Figure 5-5, by working the belt off of the two drive
pulleys.
7. Replace the belt and reassemble the attachment in the
reverse order.
12 S 5 — M
ection aintenance
Figure 5-4
Figure 5-5
& a
djuStMentS
Clutch Bumpers
It is necessary to check the clutch bumpers, installed on the
dog clutch assembly, before each use. The clutch bumpers are
wearable parts that will need to be replaced periodically after
extended usage.
To replace the clutch bumpers, follow these instructions:
1. Gently pry each clutch bumper out of the dog clutch using
a standard screw driver. See Figure 5-6.
Figure 5-6
2. Replace the clutch bumpers (Kit Part No. 753-08457) by
fully pressing them into place.