S&P TL-10 N Instrucciones De Uso página 7

and then turn the thermostat knob
to position * . In this position if the
ambient air temperature drops bellow
+5 °C the fan heater will automatically
switch on.
Maintenance
1. Important, disconnect the unit from
the mains supply before carrying out
any maintenance operation.
2. Ever y season, clean the
accumulated dust from inside the unit
with a high pressure air jet or vacuum
cleaner. It is recommended that this
operation is carried out by a qualified
technician.
3. Clean the inlet and outlet grilles
regularly.
4. The appliance should not be dipped
in water for any reason nor should it
be put under a tap.
5. Do not dismantle the appliance in
any way as this will nullify the S&P
guarantee.
6. If the supply cord of this appliance
is damaged, it must only be replaced
by repair shop appointed by the
manufacturer because special
purpose tools are required.
Remark: it is very important that
regular maintenance of the fan
heater is carried out in order to reduce
the risk of possible fire hazards.
Overheating, switch off
In the event of overheating due to any
abnormal operation or failure, the
safety protection device will
automatically switch the unit off. In
this event:
1. Disconnect the appliance from the
mains supply.
2. Allow the unit to cool down for at
least 15 minutes.
3. Make sure that the outlet grille is
not obstructed by dust and if
necessary it can be cleaned with a
vacuum cleaner.
If after these actions the appliance
still does not work properly, we
recommend that it be taken to your
S&P dealer.
230 V ~ 50 Hz 2.000 W
7