Mounting; Troubleshooting - La Crosse Technology WS-9002U Manual De Instrucciones

D. VIEWING AND OPERATING WITH MULTIPLE REMOTE TEM-
PERATURE SENSOR UNITS
1. To view the temperature of a different remote temperature sensor
unit, press and release the "CH" button. A shift from one "boxed"
number to the next should be observed in the OUTDOOR LCD.
2. To view the Minimum/Maximum temperature: first select from which
remote temperature sensor to read data (indicated by the "boxed"
number). Pressing and releasing the "MIN/MAX" button will toggle
through the minimum and maximum indoor temperature, and the
minimum and maximum outdoor temperature.
3. To reset the Minimum/Maximum readings, press and hold the "MIN/
MAX" button for five seconds.
GB
P.13
B. THE TEMPERATURE STATION
1. The indoor temperature station comes with the table stand already
mounted. If you wish to use the table-stand, all that is required is to
place the indoor temperature station in an appropriate location.
2. To wall mount, remove the table stand. To do this, pull down on the
stand from the rear and rotate forward.
a) Fix a screw (not included) into the desired wall, and place the
indoor temperature station onto the screw using the hanging hole
on the backside. Gently pull the indoor temperature station down
to lock the screw into place.
GB
P.15
2. Place remote temperature sensor closer to the indoor temperature
station.
3. Be sure all batteries are fresh.
4. Place remote temperature sensor and indoor temperature station
in position so the straight-line signal is not passing through more
than two or three walls.
Problem:
Temperatures do not match if units are placed next to each other.
Solution: Each temperature sensor is manufactured to be accu-
rate to within 1 degree plus or minus and under normal conditions; so
two temperature sensors could be as much as 2 degrees different.
GB
P.17
III. MOUNTING
Note: To achieve a true temperature reading, avoid mounting in direct
sunlight. We recommend that you mount the remote temperature sen-
sor on an outside North-facing wall. The sending range is 80ft; ob-
stacles such as walls, concrete, and large metal objects will reduce
the range. Place both units in their desired location before perma-
nently mounting.
A. REMOTE TEMPERATURE SENSOR
1. Remove the mounting bracket from the remote temperature sensor
2. Mount using either screws or adhesive tape.
3. Reattach the remote temperature sensor to the mounting bracket.

TROUBLESHOOTING

NOTE: For problems not solved, please contact La Crosse Technol-
ogy via e-mail or phone, or visit our website, www.lacrossetechnology.
com
Problem: The LCD is faint
Solution: Replace batteries
Problem: No outdoor temperature is displayed.
Solution:
1. Remove all batteries, reinsert into remote temperature sensor first,
and then into the indoor temperature station.
However, the difference can be exaggerated further because the tem-
perature sensors are designed for different working environments. The
indoor sensor is less responsive to ambient air currents because of
the shielding effect of the display's case. In addition, the case can act
as a heat sink to absorb and store heat from external sources (i.e.
handling of the case or radiant heat). In addition, the much greater
range of the outdoor temperature sensor requires a different calibra-
tion curve than the indoor range. Error is usually greater at the ex-
treme ends of a range, making it harder to compare different ranges
with different curves. Under non-laboratory conditions, it is difficult to
compensate for the above factors and obtain an accurate comparison.
GB
P.14
GB
P.16
GB
P.18