Preparation; Charging The Trimmer - Panasonic ER‑GD60 Instrucciones De Operación

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 75

Preparation

Charging the trimmer

• Make sure that the trimmer is turned off.
1
Connect the appliance plug
to the appliance socket.
2
Plug in the adaptor into a
household outlet.
• Check that the charge status lamp
(
) glows.
• Charging is completed after approx.
1 hour.
3
Disconnect the adaptor when the charge status
lamp stops glowing.
(for safety and to reduce energy usage)
<To check if charging is completed>
If you remove and reinsert the appliance plug while charging,
the charge status lamp glows and turns off after
approximately 5 seconds.
Notes
• If there is crackling noise on radios or other devices while
charging, charge the trimmer using a different household outlet.
• When the appliance is not used for 6 months or more, the battery
will weaken (leak battery fluid, etc.). Fully charge the battery
once every 6 months.
• When charging the trimmer for the first time or when it has not
been in use for more than 6 months, the lamp on the main body
may not glow for a few minutes, or the operating time may
shorten. Please charge it for more than 8 hours in such cases.
10
• Recommended ambient temperature for charging is 0 °C – 35 °C.
The charging time may change or battery performance may
decrease outside of the recommended temperature.
• A full charge supplies enough power for approximately
50 minutes of use. (Based on dry using at 20 °C ‑ 30 °C.)
The operating time may differ depending on the frequency of
use, the operating method and the ambient temperature.
• You can charge the battery before it is completely discharged.
However, it is recommended to charge when the battery is
completely discharged. The battery life depends strongly on
2
factors such as how it is used and stored.
AC operation
1
If you connect the AC adaptor to the trimmer in the same way as
for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Er‑gd50

Tabla de contenido