Pro-Lift W-1704 Instrucciones De Operación página 3

Fused 12V
DC Plug
Quick Connector
Large Diameter
Air Hose
OPERATION
A. High Pressure Inflatables (Tires)
1. Remove air hose with Quick Connect from storage com-
partment and, with thumb latch Quick Connector open,
place securely onto tire valve stem (Fig. 4).
2. Use thumb to close Quick Connector, ensuring that the
thumb latch is as far down as possible.
Figure 3
Figure 4
Sports Adapter
Adapters for Inflatables
Figure 5
3. Set the Pressure Gauge to the desired value by rotat-
ing the dial until the needle aligns with the appropriate
pressure.
4. Remove Power Cord from storage compartment and
insert into a suitable outlet or 12V DC source. Toggle
COMPRESSOR/INFLATOR switch to INFLATOR posi-
tion. Unit will begin inflating.
5. Compressor will inflate tire (or other high pressure inflat-
able) to the preset pressure, then automatically shut off.
6. Toggle COMPRESSOR/INFLATOR switch to OFF (cen-
ter), disconnect Quick Connector and unplug the power
cord. Replace air hose with Quick Connect and Power
Cord in their respective storage compartment.
7. Use a tire gauge to check inflation and adjust to desired
pressure as recommended by the vehicle and/or tire
manufacturer.
NOTICE: If tire is at higher pressure than value set on
gauge, compressor will not start.
NOTICE: Do not rotate gauge dial during inflation.
NOTICE: Always double check air pressure using a reli-
able pressure gauge.
B. Low Pressure Inflatables
NOTICE: The automatic shut-off feature does not function
on low pressure inflatables.
1. To inflate air mattresses, beach balls, life jackets, and
other low pressure inflatables, remove Large Diameter
Air Hose and air hose inflator adapters (below) from
storage compartment.
2. Insert one end of Large Diameter Air Hose onto Low
Pressure Inflator Outlet and appropriate plastic air hose
inflator adapter onto other end.
3. Plug Power Cord into a DC 12V outlet. Toggle COM-
PRESSOR/INFLATOR switch to INFLATOR position.
Unit will begin inflating.
4. Inflate to a pressure or level of firmness recommended
by the manufacturer. Toggle COMPRESSOR/INFLA-
TOR switch to OFF (center) and check pressure as
required.
5. Disconnect plastic hose adapter from inflatable, disas-
semble adapter from air hose and store properly.
3