Cequent Performance Products 51195 Instrucciones De Instalación

Frame rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51195F
Wrenches: 21mm
Note: Fasteners typical
both sides
1. Remove (4) existing M14 bolts (Do Not clean the threads). Retain bolt for reinstallation.
2. Raise hitch into position as shown and install fasteners as shown. If excess caulking on the
frame rail interferes with hitch installation lower hitch and scrape excess caulking for installation.
3. Tighten all fasteners to called-out torque specification.
Tighten all M14 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2010 Cequent Performance Products
Installation Instructions
Jeep Grand Cherokee
Fascia Fascia
Frame rails
Existing weldnut
both sides
Retain bolt for
reinstallation.
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: TBD
Note: Uses all
existing Bolts
on Vehicle
51195N
Part Numbers:
51195
Max Gross Max Tongue
Trailer WT (LB) WT (LB)
7500 (3405 Kg) 750 (341 Kg)
5000 (2270 Kg) 500 (227 Kg)
5-27-10
Form: F205 Rev A 5-6-05
Rev. A