Operation; Care And Cleaning - HOMEDEPOT CODE DL10490BK1-4 Guía De Uso Y Mantenimiento

Operation

Functional instruction
□
After properly installing the power pack, turn on the power pack.
There are four buttons for operation. Every time you press either button,
it will turn to another working mode. Push either button repeatedly to
move to the different selections.
□
"AU" - ON AT DUSK OFF AT DAWN (lights turn on at dusk and
turn off at dawn).
□
"1" through "12" - ON AT DUSK RUN TIME (lights turn on at
dusk and turn off after the selected number of hours).
□ n
"O /OF" - MANUAL ON/OFF (lights stay on until manually turned off).
□
"EE"- CHECK CIRCUIT. If this is displayed, power to the power pack has been
interrupted or too many lights have been installed. Immediately check the following:
□
Is the cable correctly inserted into the power pack terminals?
□
Is the unit overloaded or are the wires touching?
□
□
After the problem is solved, press "RESET" key to reset the unit.
□
To save energy, the display will turn itself off after 20 seconds. Press any key to re-activate the display setting except the "RESET"
key.
□
This power pack retains the last setting of operation when the power pack is turned off.
□
To restore the power pack to its original factory settings (Photocell Auto ON/OFF), press and hold the MANUAL ON/OFF button for 10
seconds until the display shows 88 and all the indicator lights are lit.
□
To test the photocell during the day, plug the power pack into a 120-volt covered GFCI outlet. Press the setting button to "AU",
making sure the photocell is completely covered, and the lighting will turn on. When you remove the back plastic cover from the
photocell, and the photocell senses direct sunlight, the light will turn off. The proper area for the power pack is an area where the
photo eye can sense direct sunlight. This is needed so the photo eye feature works properly. If the photo eye cannot sense direct
sunlight, then the lights may not turn on and off properly.

Care and Cleaning

□
□
Use a dry or slightly dampened, clean cloth (use clean water, never use a solvent) to wipe the interior and exterior surfaces of the
□
CAUTION:
8