Truper TPN-875 Manual De Instrucciones página 8

Cutting Disc
(Not Included)
• Confirm that the wheel size is compatible with the grinder
and spindle size.
• Use only discs specified for grinding wheel r/min or larger.
WARNING • Disconnect the grinder from the air
supply before inserting or removing the cut-off wheel.
• Use the included wrenches to change the cut-off wheel.
• Place the inner flange (A), the disc (B) (not included) and
the outer flange (C) on the spindle (D).
• Hold the spindle with the wrench (E) while tightening the
outer flange with the two-prong wrench (F) by turning
clockwise until the cutt-off disc is correctly positioned.
• Make sure that the cut-off wheel is correctly mounted and
tightened. Remove the wrenches and run the tool without
load for 30 seconds in a safe position. Stop immediately if
you detect any defects in the installation.
NOTE
The disc is not included with
the equipment. Purchase discs in your
Authorized
Distributor.
F
Air Inlet Connection
• Remove the plastic plug covering the air inlet at the base
of the handle.
• Connect the air hose to the tool using an adapter (not
included) by screwing the adapter to the air inlet of the
tool.
• In case of working with different pneumatic tools and a
single compressor, the use of a quick coupling (not
included) together with the adapter is recommended for
quick connection and disconnection of the tools and easy
interchangeability.
8
ENGLISH
Installation
B
C
Assembly
E
D
A
Air Hose
Adapter
Plastic
Cap
Air Inlet