Manuales relacionados para Truper ERGO-PRO ERGO-4580
Resumen de contenidos para Truper ERGO-PRO ERGO-4580
- Página 1 Manual Angle 1.1 Hp ” grinder Power Disc Applies for: Code Model 18156 ERGO-4580 ERGO-4580 Read this manual thoroughly CAUTION before using the tool.
-
Página 2: Tabla De Contenido
Contents CAUTION Technical Data Power Requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for angle grinders of fatal injuries please read and understand this Manual before Parts using the tool. -
Página 3: Technical Data
Technical Data ERGO-4580 Code 18156 Description Angle grinder Discs ” Voltage 127 V Frequency 60 Hz Current Power 1.1 Hp Speed 12 000 RPM Duty cycle 30 minutes work per 15 minutes idle. Maximum 3 hours per day. Conductors 18 AWG x 2C with insulating temperature of 221 °F Insulating IP Grade IP20... -
Página 4: General Power Tool Safety Warnings
General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For Angle Grinders
Safety warnings for angle grinders This power tool is intended to function as a cutting tool. Read all safety warnings, instructions and specifications provided.Failure to follow the instructions outlined below may result in electric shock, fire and/or serious injury: While operating the grinder Select the right disc CAUTION •... - Página 6 Safety warnings for angle grinders DANGER KICKBACK (Sharp Recoil) Do not use accessories that are not specifically designed and recommended by the manufacturer. The fact that the Kickback (sharp recoil) is a sudden reaction when a rotating wheel, backrest, brush, or other accessory gets accessory may be installed on the power tool does not ensure safe operation.
-
Página 7: Parts
Parts Lock nut wrench (Included) Protective Axis LED, Power guard Handle lock indicator Clamp lever Switch ” abrasive Axis disc included model ABT-386 lock Auxiliary handle Protective Outer guard ” abrasive flange disc included Switch Inner flange Auxiliary handle assembling orifice Power cord protector Clamp... -
Página 8: Start Up
Assembly Auxiliary handle assembly • For a safer operation use the auxiliary handle. Fit it into any of the three mounting orifices. Use the one that makes your job easier. Start Up The angle grinder is a manual power tool used to grind and cut steel, pipes, iron angles, brick, tile, stone and / or ceramic pieces;... -
Página 9: Maintenance
Maintenance • Always disconnect the tool before cleaning. • Never use water or other liquids. Use only a brush. • To prevent the motor to overheat clean the ventilation slots regularly. • Check all the tool components are perfectly fixed. •... -
Página 10: Notes
Notes ENGLISH... -
Página 11: Authorized Service Centers
Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. -
Página 12: Warranty Policy
. Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Stamp of the business.