Getting Your Baby Monitor Ready - Philips SBC SC463 Manual De Instrucciones

2 2 ENGLISH
Your baby monitor
SBC SC463
Philips is dedicated to producing caring, reliable products that new moms
and dads really need. Products whose reliability and operating quality bring
reassurance. You can trust this Philips baby monitor to provide round-the-
clock support by ensuring you can always hear your baby clearly, no matter
where you are in the house.
A
Product illustration on Baby unit
inside flap: 1 DC power supply socket
2
power button
3 power light
4
channel selection switch
5 microphone
6
AC power adapter
7 microphone sensitivity control
8
battery compartment cover
Important information
Please read this guide carefully before using the baby monitor, and keep it
for future reference. This baby monitor is intended as an aid. It is not a
substitute for responsible and proper adult supervision and should not be
used as such.
• Make sure the Baby unit and adapter cable are always out of reach of the
baby, at least one metre away.
• Never place the Baby unit inside the baby's bed or playpen!
• Never cover the baby monitor (with a towel, blanket, etc.).
• Clean the baby monitor with a damp cloth.
• Never use the baby monitor near water.
IFU463.p65 2-3
B
Parent unit
9 system check light
10
DC power supply socket
11 AC power adapter
12
power light
13 volume control - on/off switch
14
channel selection switch
15 loudspeaker
16
battery compartment cover
17 system check alarm switch

Getting your baby monitor ready

1
Position the Baby unit at least one metre away from your baby.
Never place the baby unit inside the baby's bed or playpen.
2
Set channel selection switches to the same channel on both units.
3
Connect the power adapter to Baby unit socket.
4
Plug the power adapter into mains supply.
5
Move away from the Baby unit with the Parent unit.
If units are positioned too close to each other then a high-pitched noise
can be heard.
6
Connect the second power adapter to the Parent unit's socket.
7
Plug the second power adapter into a mains supply.
Using your baby monitor
Listening to your baby
1
Push the power button on the Baby unit to turn it on.
POWER
> The power light lights (green).
2
Adjust the microphone sensitivity of the Baby unit to a level you prefer
(using your own voice as a sound reference).
I > The power light lights (yellow) when a sound is picked up.
3
Switch the Parent unit on and adjust the volume to level you prefer using
the VOLUME ON/OFF control.
The SYSTEM CHECK light lights continuously (green) when the Parent unit
and Baby unit are in touch with each other.
17/01/2002, 19:29
ENGLISH
3