Klarstein 10029856 Manual De Instrucciones página 19

Setting timer on
When the air conditioner is in standby state, press TIMER, the timer LED lamp is on, and meanwhile the display
will flicker "00" for 5 times, at the moment press UP/DOWN to adjust the desired time, and the method of
adjustment is the same as that during timer off. During setting of timer, the operating modes after start can
be selected, if COOL mode is selected, the set temperature can be adjusted simultaneously; if DEHUMIDIFY
mode is selected, the set humidity can be adjusted simultaneously. After the set time expires, the air conditio-
ner starts automatically and runs in the selected operating mode.
Change of the set time / Turning the timer off
In the running process of timer, if you are intended to change the existing timer, you can press TIMER once, at
the moment 88 Nixie tube will flicker and display the remaining time, during flicker pressing UP/DOWN can
increase/decrease time on the basis of the original time. If you press TIMER again during flicker, the set time
will be cancelled, namely timer quits.
COOL and HEAT mode
• In on or timer on state press MODE to select COOL or HEAT mode. At the moment the corresponding LED
on panel displays.
• Press UP/DOWN to set appropriate temperature in a range of 18~30°C (64-86°F). When UP or DOWN is
pressed once, temperature will go up or down by 1°C or 1°F every time.
• Press SPEED to select appropriate speed, and LOW, MID and HIGH speeds can be circularly selected.
• After selecting COOL or HEAT mode, press SLEEP on remote control (or press UP and TIMER on operating
panel simultaneously) to enter SLEEP mode, both upper and lower fans are forcibly set at LOW speed. In
approximate 7h the air conditioner turns off automatically. If SLEEP is to be cancelled, press SLEEP again or
conversion mode to cancel the sleep function.
• Press SWING to turn off or turn on the swing function.
DEHUMIDIFY mode
• In on or timer on state press MODE to select DEHUMIDIFY mode. At the moment the corresponding indi-
cator lamp is on.
• Temperature and speed are not adjustable.
• Press SWING to turn off or turn on the up/down swing function.
FAN mode
• In on or timer on state press MODE to select FAN mode. At the moment the corresponding indicator lamp is on.
• Press SPEED to select appropriate speed, and LOW, MID and HIGH speeds can be circularly selected. In this
mode press SPEED for "5s" to run the internal dry function, i.e. both upper and lower fans work simultane-
ously. Press SPEED for another " s" to cancel the internal dry function.
• Temperature is not adjustable.
• Press SWING to turn off or turn on the up/down swing function.
19