Towing Products 81642 Instrucciones De Instalación página 2

1. Remove the factory tie down bracket from bottom of left rear frame section. Discard tie down bracket an
two fasteners.
2. Position receiver assembly up against bottom of left and right vehicle frame in line with the existing weldnuts in frame.
3. Bolt receiver frame brackets to vehicle frame with the 40mm bolts #3 and 1/2" conical washers #2 as illustrated.
4. Tighten all 12mm bolts to 75 ft. lbs. torque. Failure to tighten bolts as described may result in fastener loss or failure.
For information regarding the installation of this product, go to: www.towingsupport.com
or Email us at: tech@towingsupport.com or Call our Technical Support Team at: 1-800-344-3230
This product complies with regulation V-5, C.S.A Standard D-264 and safety requirements for connecting devices
and towing systems of the State of New York
81642