Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.1 Available Discs
The Food Grater is a bench top machine developed to grate
or shred cheese or dried coconut, being also able to process
all kinds of vegetables, keeping their nutritious properties,
and also avoid wasting.
In table 02, the available blades and their cutting dimensions
and codes are indicated.
BLADE
DEMONITATION CUTTING DIMENSIONS
Blade 4
Blade 8
Grating Blade
3. INSTALLATION AND PRE-OPERATION
3.1 Positioning
Your appliance must be positioned and leveled on a dry and
firm surface with a preferable height of 850 mm.
3.2 Electrical Installation
The feeding cable has 3 pins, and the central pin is for
grounding. It is mandatory that the 3 pins are turned on
before turning on the appliance.
3.3 Equipotencial terminal
The Picture presented below indicates the external
equipotential terminal.
It must be used to guarantee that there is no potential
difference between different equipment connected to the
power grid, diminishing the risk of electric shocks.
The distinct equipment must be turned on one to the other
by their own equipotential terminals.
PICTURE 02
3.4 Safety system
For the safety of the operator, this appliance has 3 devices
that are capable of turning off the machine and preventing
accidents.
a - For the safety of the operator, this appliance has 3 devices
that are capable of turning off the machine and preventing
accidents.
Table 02
Diameter of 4 mm
66208.9
Diameter of 8 mm
66226.7
xxxxxxxxxxx
66195.3
Terminal
b - The second device interrupts the operation of the
machine when the pushing bottom is on, opening the
feeding nozzle. When the pushing bottom returns to its
position, the machine starts automatically to work.
c - The third device shuts down the machine's motor in the
event of overheating. Wait a few minutes until the machine
cools down and turn it on again by pressing the ON Switch.
3.5 Replacement of the discs
To replace the disc follow the steps below:
Step 1: Release the handle no. 01 (Pic. 03) turning it to
CODE
counter-clockwise;
Step 2: Remove the feeding nozzle no. 02 (Pic. 03);
Step 3: After that, with a cross tip screwdriver, loose the
screw no. 03 (Pic. 03) that attaches the disc plate;
Step 4: Remove the disc and put the one that will be used;
Step 5: With the cross tip screwdriver tighten the screw
again;
Step 6: Slot the nozzle set and attach it to the maniple,
turning it on clockwise.
02
01
4. OPERATION
Never operate this appliance when close to the border
of the work surface.
•
Check if the appliance is firm to the working area.
•
Before using the appliance, it is necessary to wash all
the components that have contact with the product
that will be processed with water and neutral soap.
4.1 Turning on the Appliance
Before turning on the equipment, check the following
procedures:
- Check if the feeding mouth is closed and correctly locked;
- Check if the pusher is correctly positioned inside the nozzle
PICTURE 03
03
PICTURE 04
Publicidad
Tabla de contenido
