Valore VS-1000C Plus Manual De Instalación Y Utilizacion página 8

• Insert the Bracket (Part 13) onto the Brass
Extender Joint (Part 15)
• To ensure the bracket (and your shower panel)
will be in a completely straight and level position,
use a level tool against the side of the bracket
guide to make fine adjustments to the bracket
guide's position until fully level.
• Once fully level, this will be the final position of
the bracket guide.
• Take a pencil/marker and lightly mark the vertical
position of the Bracket (Part 13).
a. Peel off the paper backing to the adhesive on the
back side of the Bracket (Part 13).
b. Place the adhesive side to the wall and apply
pressure to secure the Bracket(Part 13).
(Note: Clean all residues from the wall to insure
the cover will bond properly)
c. Place the Rubber Washer (Part 8) and nut over
the Brass Extender Joint (Part 15), and tighten
the nut (Part 7) to secure the bracket (Part 13)
to the extender joint (Part 15).
INSTALLATION INSTRUCTIONS
- 8 -
15
4
13
5
13
6
a
b
13
c
15
8 7
13 13