Disposal Of Product; Compliance With Ec Regulations; Mounting The Ctx To The Wall - Favero CT4X Manual De Instalación

1.5 Disposal of product

Please dispose of your product in a manner most
compatible with the environment and in accordance
with federal or state laws, reusing parts and
recycling components and materials when possible.
When this crossed-out waste bin symbol is
attached to a product it signifies the product
should be disposed of in a separate
container from other waste. The sorted waste
collection of the present device is organized
and managed by the manufacturer. Users
who wish to dispose of their present device
should contact the manufacturer and follow
the procedure indicated for separate waste
collection.
Ensuring proper sorted waste collection in
accordance with environmental standards,
for the disposal of further devices helps to
protect the environment and the health of
persons from any damaging effects. It also
favors the reuse and recycling of materials.
Administrative sanctions, in accordance with
regulations in effect, will be applied for any
improper or abusive disposal of the product
on part of the holder.

1.6 Compliance with EC regulations

The CTx meets the necessary requirements for
electromagnetic Compatibility
regarding electronic equipments, according to
European regulations:
• 2004/108/EC of 15 December 2004
• 2006/95/EC of 12 December 2006
2 M
OUNTING THE
Install the CTx in a dry place free from any risk of
water damage. If installed outdoors, it must have
protection from the rain.
As an option the CTx can be supplied with
protection from
(International Protection Rating IP34).
To mount to wall:
Determine the position by also taking into
•
consideration the path of the connection cables
(power supply cable for CTx and cable for the
relay unit). See chapter 4 and 5 for information
on connections.
Remove the protection case by unscrewing the
•
three screws indicated in Fig. 1.
Fasten the CTx via the 4 holes at the bottom, as
•
indicated in Fig. 2 Make sure the device is
fastened vertically to guarantee the proper
functioning when coins are inserted.
F E D
AVERO LECTRONIC ESIGN
and
CT W
X TO THE ALL
rain and splashing
Proceed with the electrical connections as
•
indicated in chapter 4 and 5.
Replace the protection case as indicated in Fig. 1.
•
1) Fastening screws of the protection case
Fig. 1: Protection case of the connections
Security
water
1) Entrance for cables (grommets)
2) Holes for fastening to wall
3) Electronic board
4) Power supply
5) Cable clamp
Fig. 2: Mounting the CTx
Pag. 3 / 26 00182-M05-02-ML - Manuale installazione
ENGLISH