KNOVA KN RXW-10Q Manual De Instrucciones página 9

ASSEMBLE AND ADJUSTMENTS
CHANGING THE SAW BLADE
Attention: left hand thread.
Remove the arbor nut (J) and flange (I).
Place saw blade on arbor shaft making sure teeth point down
at the front of the saw.
Reinstall flange and arbor nut and securely tighten.
Remove the locking pin (K).
Check the correct position of the raving knife in regards
to the saw blade (see the next section).
Reinstall the saw guard.
K
I
Fig. 11
Blade
MOUNTING AND ADJUST THE RIVING KNIFE
The supplied riving knife must always be used.
The riving knife has to be adjusted in such a way that over its
entire length the gap between saw blade and riving knife does
not exceed min.3 mm and max.8 mm (Fig 12).
Fig. 12
Blade
washer
Arbor
shaft
Blade nut
Fig. 11
3 -8 mm
The handle(L) should keep up as Fig.13. When install
the riving knife. Then fix the handle(L) by rotation after
riving knife installation as Fig.14.
J
TO ADJUST THE RIVING KNIFE:
1. Disconnect the saw from the power source.
2. Move the blade tilt to 0º (blade 90º to table)
and raise the main blade all the way up.
3. Check both sides of the blade with a straight edge
touching the teeth as shown in Figure 15:
---If the straightedge touches the riving knife
evenly on both sides, go to step 4.
---if the straightedge only touches the riving
knife on one side, go to step 5.
Fig. 15 (checking riving knife alignment)
8
L
L
Fig. 13 Fig. 14