F
M
OR
ODEL EA
The Auger Adapter allows auger bits and extension with a 1
in. shaft diameter to be installed on the EA-400 Auger, or EA-
400 with a 7/8 in. diameter auger extension.
C
ONTENTS
1 - Auger Adapter (7/8 in. socket to 1 in. shaft)
1 - 3/8 - 16 x 1-1/4 in. SAE Grade 5 Hex Socket Screw
1 - Installation Instructions
I
NSTALLATION
Tools Required: 5/16 in. hex socket wrench.
Parts Required:
Auger Adapter, Hex Socket Screw
Adapter
1. Carefully place engine on a flat surface with muffler side
down.
2. Remove auger mounting hardware and 7/8 in. shaft auger
bit if installed.
3. Install auger adapter on auger PTO shaft and align
mounting hole in adapter with hole in PTO shaft.
4. Secure adapter to auger PTO with (1) hex socket screw.
5. Install 1in. auger bit on adapter, and secure with hardware
provided with auger bit.
Extension
NOTE:
Adapter may be used with an auger extension to increase
drilling depth. Follow all instructions provided by auger
extension manufacturer.
WARNING
Never operate auger with handles above chest height.
Loss of control and serious injury may result.
The muffler and area around the muffler may be extremely
hot. Avoid contact with this area, otherwise serious
injury may result.
1.
Drill to depth suitable for safe extension installation, and
stop engine.
X7504220200
-
400
DANGER
I
NSTALLATION
Auger Adapter, P/N 99944900330
WARNING
Read and comply with all safety and operating
instructions in your Power Auger and auger bit
Operator's and Instruction Manuals.
2a.
7/8 IN. DIA. SHAFT EXTENSION :
A. Remove assembly hardware from PTO shaft
and remove engine. Adapter remains on
auger bit.
B. Attach extension to auger bit.
C. Install engine PTO shaft into extension.
2b.
1 IN. DIA. SHAFT EXTENSION :
A. Remove assembly hardware from auger bit
and remove engine with adapter.
B. Attach extension to auger bit.
C. Install engine with adapter into extension.
3.
Check all hardware for secure assembly before
resuming operation. Replace worn or damaged
hardware.
I
NSTRUCTIONS
DANGER
X750005450
02/03