Amann Girrbach giroform Modo De Empleo página 11

STARTING UP
!
ATTENTION:
For transportation,
always hold the pin drill
at the vertical column,
never at the (horizontal)
laser arm!
CONNECTION TO ELECTRICITY
#
!
main switch
@
laser (3A < 5 mW)
#
triggers
Power connection at back, power cable (220V/320W)
(both not visible here)
@
#
!
ADJUSTING THE DRILLING DEPTH
The burr rests on a slotted screw in the center of the
axis. Clockwise turns lower the screw = tighter drill
hole; counter-clockwise turns raise up the screw =
wider drill hole. The wider the drill hole, the farther
the pin tip juts out of the plinth plate.
REPLACING THE BURR
Unplug the power cable. Insert the fixing pin from
the side into one of the holes of the drilling axis.
Turn the tubular socket wrench in counter-clockwise
direction to unscrew the sleeve nut. Then, remove the
defective burr.
GB
11