ABC Design Mint Instrucciones De Uso página 10

Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the product
or by exceeding the permissible load.
• No claims may be made for damage caused by improper use.
• No claims may be made for damage caused by incorrect assembly or operation.
• No claims may be made for damage caused by improper modifications to the product.
• Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with
the product.
• Scratch marks are normal signs of wear and do not constitute a fault with the product.
• Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to
shortcomings in production conditions.
• The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or
excessive washing, therefore fading cannot be attributed to a fault with the product.
• No claims may be made for wheels which become worn out as a natural result of wear and tear.
1. Opening the pushchair
a. Release the transportation lock.
b. Pull the handle on the stroller (1) upwards until the frame clicks into place (2).
WARNING: Ensure that all the catches are engaged before use.
2. Fitting the wheels
a. Press and hold the button on the rear wheel fitting and insert the rear wheel in
opening.
In order to remove each wheel, press the button on the rear wheel fitting in order to
disengage the wheel.
The wheel can then be removed from the axle.
b. Insert the front wheel in the slot until it clicks into place.
c. To remove the front wheel, press the button on the front wheel fitting and pull the wheel
out.
3. Lock and unlock setting on swivelling wheels
Move the catch to the left for swivel mode and to the right for locked mode.
4. Using the brakes
Press the lever down to apply the brakes.
Press the lever up to release the brakes.
5. Fastening the harness
a. In order to close the harness, first insert the plastic fittings on the lap restraints in the
plastic fittings on the shoulder belts on both sides.
b. Then insert the fittings into the crotch strap fastening.
Adjust the harness to a setting where the baby is held in the correct position.
c. To open the harness, press the catches in on both sides.
6. Attaching the hood
EN - 05
the