Cleaning And Maintenance - Bimar PA100 Manual De Instrucciones

To operate the appliance, insert the plug into the wall socket: the "
up in red (indicating stand-by mode); to start the purifier, press "
symbol lights up) and select the required functions.
To stop the appliance, press "
turn off the appliance completely, remove the plug from the plug point.

CLEANING AND MAINTENANCE

Important: before performing routine cleaning, remove the plug from the mains.
 Regularly check that the filters are clean to ensure operation remains as effective as
possible.
 PRE-FILTER: clean the filter when the "PRE" light on the control panel lights up
(about every 1500 hours of operation, but depends on the air quality of the room);
to reset the light, press the "TIMER" and "UV" buttons at the same time for 3
seconds, or periodically ensure that the rear extraction grille is not blocked by fluff
or lint. If the filter is dirty, remove the grill and clean the mesh using a brush or
water, taking care not to damage it; then dry it completely and put it back in its
seat.
 HEPA FILTER:
replace the filter when the "HEPA" light on the control panel lights up (about every
-
3000 hours of operation, but it depends on the air quality of the room); to reset
the light, press the "TIMER" and "UV" buttons at the same time for 3 seconds, and
replace the filter only with original spare parts.
do not clean the filter with a vacuum cleaner
-
do not wash and reuse the filter
-
 Always wash hands carefully after replacing or cleaning the filter.
 To clean the body, use a soft cloth dampened with water and, if necessary, use also
a mild everyday detergent.
 Do not use abrasive or corrosive products.
 Do not immerse any electrical parts in water or another liquid. In the event this
occurs, dry carefully and check that the electric parts are completely dry. Only
thereafter, plug the appliance into the mains. If in doubt, contact a qualified
professional.
 If the appliance is not used for long periods of time, you should store it away from
dust and moisture; we recommend using the original packaging.
 If you decide to no longer use the appliance, it is recommended that be made
inoperative by cutting the power cord (first ensure that the appliance has been
unplugged from the power supply), and ensure that any parts that could represent
a risk to playing children are put away.
" and the symbol will turn red and remain on. To
19/52
" symbol lights
" (the blue