Dc And Ac Voltages (V); Resistances (Ω); Continuity Sound Test ( ) - Chauvin Arnoux C.A 5205 Manual De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

3 - DC AND AC VOLTAGES
I Connect the leads to the multimeter and connect it in parallel to the
circuit to be tested.
I Place the selector switch on the voltmeter function V. Automatic
selection of the range and the DC or AC mode; read the value measured.
I Memorise the value, if necessary, by pressing the HOLD button.
NB: On V AC, to benefit from HOLD, do not disconnect the leads.
V DC
AC
200 mV
(1)
(2)
and
Resolution
0.1 mV
Impedance
Accuracy
Permitted
overload
(1) Use on frequency: 40 Hz to 500 Hz
Min. threshold on V AC: 25 mV from 40 Hz to 100 Hz and 300 mV from 100 Hz to 500 Hz
Min. threshold on V DC: 10 mV
(2) V ...
only
Note: Because of its high input impedance, the instrument sweeps the ranges
when the leads are in the air.
4 - RESISTANCES
Never test a resistance on a live circuit
I Connect the leads to the multimeter and to the circuit or the
component to be tested.
I Place the selector switch on the ohmmeter function Ω
I Automatic range selection: read the measured value
I Memorise the value, if necessary, by pressing the HOLD button.
Ω Ω Ω Ω Ω
200 Ω
0.1 Ω
Resolution
± 1.5 % rdg
Accuracy
± 5 counts
Voltage on
open circuit
Protection
5- CONTINUITY SOUND TEST
I Connection and protection: idem Resistances
I Place the selector switch on the
I Continuous audible beep emitted for a resistance R - 700 Ω
12
2 V
20 V
200 V
1 mV
10 mV
100 mV
3 MΩ
on DC: ± 1 % reading ± 1 count
on AC: ± 1 % reading ± 5 counts
600 V rms and 900 V peak
2 kΩ
20 kΩ
200 kΩ
2 MΩ 20 MΩ
1 Ω
10 Ω
100 Ω
1 kΩ
± 1.5 % rdg
± 3 % rdg ± 5 counts
± 3 counts
≤ 0.5 V
500 V rms and 750 V peak
function
600 V
1 V
10 kΩ

Publicidad

Tabla de contenido
loading

Tabla de contenido