Charging The System - Rena Ware AQUA NANO CTU-100 Uso Y Mantenimiento

9. Place the Aqua ✓ Nano on a flat counter surface near the sink. With the Wand
pointing outward over the sink, turn on the water and divert it through the filter
by turning the lever on the Diverter Valve 90°. Check for leaks. To stop the flow
through the filter, turn off the faucet or turn the lever in the opposite direction.
10. If needed, adjust the hose length between the Inlet Assembly and the Diverter
Valve to accommodate the cover. To make it longer, feed the tubing into the base
from the Diverter Valve end and pull it out at the inlet end.
To make it shorter, feed the tubing into the Base from the inlet end and pull it out
the diverter end. Do not pull the tubing too tightly over the filter cartridges as this
may restrict flow.
11. Place the cover on the base assembly.
12. Run water through the filter for 5 minutes to remove any small carbon particles and
expel excess air.
10
CHARGING THE SYSTEM: To improve the flow rate and to reduce the "run on" of
water after the faucet is turned off the system needs to be "charged". Charging purges
trapped air from the system.
a. Run water through the system for about a minute to saturate the media.
Remove the pre-filter cartridge being careful to minimize the water that
spills onto the base unit.
b. Pour water into the top hole
to fill the NanoCeram® cartridge.
c. Re-install the pre-filter cartridge and again pour in water into the top hole of
the pre-filter cartridge until it is full.
Your Rena Ware Aqua ✓ Nano Water Filter is now ready for you to enjoy!
11