Kohler K-T9492 Guia De Instalacion página 6

Discard
plaster guard
Valve Stem
with dome.
Faceplate
Screws
Notch
Graphics Ring
Sleeve
4. Install the Faceplate and Handle
CAUTION: Risk of product damage to the K-306–KS valve
assembly. When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Remove and discard the plaster guard and/or dome, if installed.
Install the faceplate onto the valve so the notch is to the bottom
and secure with screws. Do not overtighten the screws.
Install the graphics ring to the faceplate, and rotate it clockwise to
lock it in place.
Rotate the valve stem fully counterclockwise.
Fit the sleeve onto the valve.
Lever Handle
Position the handle so the lever is downward and press the
handle on the valve stem.
Secure with a lock washer and screw.
Press the cap on the knob so the dot is downward.
Round Handle
Position the knob on the valve stem and secure with a lock
washer and screw.
Install the grip ring and O-ring to the knob.
Press the cap on the knob so the dot is downward.
085723-2-AE
Valve Stem
Lever Handle
Lock Washer
Screw
Knob
Cap
Grip Ring
Lock Washer
O-Ring
6
O-Ring
Kohler Co.