Dcm VST33I Manual De Usuario página 8

HIPERTERMINAL mode
The first steep is to choose the correct mode. In order to do this a string "mode" is sent.
If sent a second time it will be switched to program mode.
The following will appear on the screen:
STROBE CONTROLLER. (c) DCM Sistemes 2007
Model VST33I -- SW v1.90
AVAILABLE COMMANDS
s.- Select output
r.- Show selected output
v.- Show selected pulse width
u.- To increase pulse width
d.- To decrease pulse width
p.- Set new pulse width
t.- Set delay time
e.- Show delay time
c.- Set trigger edge
f.- Show trigger edge
?.- Command menu
Show the command menu and it is ready for use.
Command s – Select output
The following will appear:
Available exits [1,2,3], Any other = Cancel
Output selected =
The desired output number should then be introduced.
Command r – Show selected output
The following will appear:
Output selected = x
Then x is the preselected output.
Command v – Show the weight pulse
The will appear:
following
DCM Sistemes S.L.
http://www.dcmsistemes.com
STROBE CONTROLLER
User manual
e-mail: comercial@dcmsistemes.com
Page 8