Dcm VST33I Manual De Usuario página 9

Pulse width = (X * 4)uS.
X is therefore the value between 0 and 2500 of the output.
Command u –
To increase pulse width
Up the pulse weight in steps of one unit. The
New pulse width = (X * 4)uS.
X is therefore the value between 0 and 2500 of the output.
Command d –
To decrease pulse width
Down the pulse weight in steps of one unit. The
New pulse width = (X * 4)uS.
X is therefore the value between 0 and 2500 of the output.
Command p – Set the weight pulse
The will appear:
following
New value [0..2500]=
The new value should then be introduced followed by ENTER
Command t – Set the delay time
Used to change the initial time of delay in steps of 410useg.
With a range between 0-27 seconds.
The will appear:
following
New value [0..65535]=
The new value should then be introduced followed by ENTER
Command e – Show delay time
Show the value of delay time.
DCM Sistemes S.L.
http://www.dcmsistemes.com
STROBE CONTROLLER
following
following
will appear::
will appear:
e-mail: comercial@dcmsistemes.com
User manual
Page 9