Bimar HO407 Folleto De Instrucciones página 14

 Stand the appliance on a horizontal, flat surface or table; Never place the
appliance on a sloping surface as this can cause it to fall over. Never lay the
electric cord under rugs or carpets.
 Make sure that the cable is positioned correctly, that it is not in contact with hot
elements or sharp edges, that it is not wound around the appliance, that it is not
twisted, or in a position which can cause the appliance to fall over. Check that
the cable cannot cause tripping in order to prevent accidental falls or injury.
ASSEMBLY
The wheel mounting brackets must be fixed to the underside (see up-down arrow
on the label placed on the appliance) and at the ends of the appliance to ensure
stability; the wheels must be pointing downwards and must be perfectly level. To
assemble follow these instructions (refer to the figures alongside):
1. Unscrew the nuts from the wheels (turning them
in an anti-clockwise direction), position the flat
washers on the pins of the screws, insert them into
the holes at the end of the bracket, position the
spring washers in place and turn the nuts in a
clockwise direction to tighten them properly.
2. Turn the radiator upside down and lay it on the ground on a cloth or other
soft surface, with the lower part facing upwards.
3. Insert the brackets with the assembled wheels in the lower part of the
radiator, moving them between the elements located at the far ends of the
radiator between:
- the last and second-last element
- the first and second element, so that the central holes of the
cross bar line up with the screws, as shown in the figure to the side.
Secure the brackets in place using the U-shaped hooks provided,
making sure that the cross bars are secured using the dedicated
wingnuts.
Thanks to the wheels, the radiator does not heat the surface on which it rests,
and air can circulate naturally. The radiator can be moved easily on its wheels,
using the folding handle at the top.
Attention: for the first use, leave it operating at maximum power for at least two
hours. During this operation, ventilate the room well to eliminate the "new" smell
emanating from the appliance.
14