Publicidad
Idiomas disponibles
Idiomas disponibles
4. Two devices are under stereo pairing connection, a series of tones should sound from both devices in
seconds;
5. The host device's "Mode LED (12)" should switch to long red light with blinking blue light for waiting
Bluetooth pairing with mobile device.
6. The slave device's "Mode LED (12)" should switch to slow blinking blue, and this device could not found
by the mobile device since it already paired as slave device of Bluetooth speaker.
8. Then now, activate the Bluetooth function in your mobile device, open and enter to Bluetooth searching
mode, the mobile device should show one of "TWIN SPEAKER" instead of two in list, choose it for start the
stereo pairing function.
9. This stereo pairing procedure is not required once stereo pairing function is activated with both
Bluetooth Speakers; two devices will stereo pairing automatically when each time you turn on them
together. Besides, you can disable the stereo pairing function by using the following methods.
Disable the stereo paring function on both Bluetooth speakers:
1. In speakers power on mode, short press the "
(2)" and "
(4)"buttons at the same time on one unit,
tones sound will heard and the stereo pair data are erased on this unit.
2. And then, short press the "
(2)" and "
(4)" buttons at the same time on the other unit, tones sound
are heard and stereo pair data are erased on this unit too.
3. And now, two speakers can be found and pairing by the mobile device.
4. Does the above mentioned methods of stereo pairing function on two speakers if you want to activate
this function again.
Note: For better result, put two devices in 5M distance range when using the Bluetooth stereo pairing
function.
N. Reset the device
1. In some circumstances the device's function may hanging and need to reset. To reset the Bluetooth
speaker;
2. To power reset the device, short press the "Reset (9)" button at the, the device is reset and turn to OFF,
and then long press the "
(1)" button to turn On and restart the device after reset is done.
O. Put two devices with special look
1. This Bluetooth Speaker(s) installed a "Magnet (11)" inside at the center position of back side for join two
devices together by using the magnetic force.
2. Put two devices back to back, it creates different outlook as one piece with two devices, see illustrate
below show:
8
Manual_P326.911_Wireless_Double_Speaker.indd 8
6-10-2016 10:25:38
Publicidad
