Care And Maintenance - Mestra R-100140 Manual Del Usuario

CARE AND MAINTENANCE

 Dry the tank and unit with a towel. Do not wash the unit completely with water to prevent the risk of shock.
 Do not load the tank excessively; it could reduce the efficacy of the bath and damage the unit.
 Do not put very heavy or large objects in the bottom of the tank.
 Use chemical cleaning products compatible with the objects to be treated. Avoid corrosive solvents.
 When items (especially valuable items) are being cleaned for the first time, carry out a trial run first with
just one item. Ask the manufacturer what cleaning solution is recommended.
 After using the unit, clean the tank and the external body with a damp cloth. Always unplug the unit before
cleaning it.
PRECAUTIONS
IMPORTANT- The input voltage of the Ultrasonic Bath transducers can reach hundreds of
volts. Therefore, it is very important to observe the following Safety Regulations:
1) Do not open the lid when the power cord is connected to the power supply.
2) Do not spill water or any other conducting fluid over the unit's housing.
3) Always connect the unit to grounded power outlets.
♦ Connect the unit to a grounded 230 V, 50/60 Hz power outlet.
♦ Do not use inflammable solvents as cleaning solutions.
♦ Keep the unit unplugged before filling it. Do not fill the tank above the max. mark. Do not start up the unit
when the water level is below the min. mark.
♦ Do not allow children or unskilled people to handle the unit.
♦ Never submerge the unit in any liquid to clean it.
♦ Ultrasonic cleaning is not suitable for organic pearls.
10
Do not turn the unit without water in the tank.
Even though the unit is designed with multiple protections, if it is turned on for over 30
seconds without water in the tank, it may damage the unit or severely reduce the life of
the unit. If heating over 3 minutes, it will damage the heater.
This unit is equipped with a thermal cutoff. If the cleaning function is turned on without
water in the tank, the temperature will rise continuously. The thermal cutoff will be
actuated after approximately 15 minutes respectively to ensure safety. The unit will be
disabled until it's repaired.
Do not turn the unit for extended time or continuously.
The unit is designed with overheat protection. If the unit has been running for 45
minutes, it is recommended to stop the unit for about 20 minutes to prolong the life of
the unit.
Do not keep water in the cleaning tank for a long time.
After cleaning is completed, turn off the switch then pour water out through the pouring
recess. Avoid getting water inside the housing through the vents and causing damage.
Do not spray water over the housing.
Use a towel to wipe the tank and the housing.
Do not expose the unit under direct sunshine for a long.
Keep the unit in a dry, cool and ventilated area.