Cleaning Solutions; Technical Specifications - Mestra R-100140 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

♦ Do not open the unit while it is connected to the power supply.
♦ The machine lid may be hot after a cycle. Proceed with caution when removing it.
♦ If you are not sure of the effects of the cleaning solution on a given type of item, carry out a previous test
with a single item.
♦ Do not attempt to remove any screw or panel. The user does not need to manipulate anything inside.
♦ To prevent electric shock, never touch the power cord or socket with wet hands.
♦ Never operate the unit if the plug or the power cord is damaged. If the unit does not work properly, is
damaged or has fallen into the water, refer it to a technical service for examination and repair.
♦ Do not touch the unit if it has fallen into the water. Unplug it immediately.
♦ Use the unit properly according to the user's guide. Do not use accessories not recommended by the
manufacturer.
♦ The unit should never be left unattended when it is plugged.
♦ Do not operate the unit next to heat sources such as radiators.
♦ Install the unit on a dry and flat surface.
Be careful that water does not enter through the ventilation slots. It could damage the electronic
circuits.

CLEANING SOLUTIONS

Cleaning solutions can be classified into two types: those consisting of a cleaning solution mixed with water,
and solvents.
The most common cleaning method is with water, as it has an acceptable capacity to dissolve inorganic
substances. However, it is extremely limited in dissolving organic substances. For this type of compound,
water is a good medium for the dispersion of dirt particles, and a good basis for specific detergents that
dissolve organic substances.
In most cases a mixture of water and domestic washing up liquid can be used as a cleaning solution.
Nevertheless, when due to the amount or nature of dirt to these cleaning solutions are not enough, specific
solvents for ultrasonic baths should be used. Under no circumstances should inflammable solvents or
environmentally dangerous products be used.
DIRT REMOVING PROCESS
The ultrasounds generate
myriads of small bubbles.

TECHNICAL SPECIFICATIONS

Voltage:
Power:
Frequency:
Tank material:
Tank dimensions:
Outside dimensions:
Max. item length:
Tank material:
Timer:
Weight:
The ultrasounds make the
bubbles implode constantly
and
impact
object's surface
230 V, 50/60 Hz
170 W
35 kHz
314 x 243 x 204 mm
245 x 150 x 76 mm
2500 ml
min: 2150 ml / max: 600 ml
260 mm
Stainless steel
1 - 30 minutes
2.9 kg
The impact breaks up the dirt
into
against
the
separates
object's surface. The grains
remain in the water.
many
grains
and
them
from
the
11

Publicidad

Tabla de contenido
loading

Tabla de contenido