Skil PS4561C-00 Manual Del Propietário página 17

To Start the Pole Saw (Fig. 8)
1. Install the battery pack.
2. Make sure that no objects or obstructions
that could come in contact with the bar and
chain are in the immediate vicinity.
3. Grasp the assist handle and the rear
handle firmly, using both hands.
4. Press and hold the lock-off button, then
squeeze the trigger switch to start the saw.
Release the lock-off button and continue to
squeeze the trigger for continued operation.
WARNING
chain is in a cut or in contact with any
surface.
To Stop the Pole Saw
Move the pole saw away from cutting area, and then release the trigger switch to stop the pole
saw.
WARNING
Cutting
Basic Cutting (Fig.9a and 9b)
NOTICE: Practice cutting a few small logs using the following technique to get the "feel" of
using your saw before you begin a major sawing operation. Follow the steps below to prevent
damage to tree or shrub bark. Do not use a back-and-forth sawing motion.
1. Make a shallow first cut (1/4 of the limb diameter) on the underside of the limb, close to
the main limb or trunk.
2. Make the second cut from the top side of the limb, outboard from the first cut. Continue
the cut through the limb until the limb separates from the tree. Be prepared to balance the
weight of the tool when the limb falls.
3. Make the final cut close to trunk.
Fig. 9a
Do not attempt to start
the saw when the saw
Always remove the battery pack from the pole saw during work
breaks and after finishing work.
Fig.8
Lock-off Button
Fig. 9b
Switch Trigger
LOAD
Second Cut
First Cut 1/4
Diameter
Final Cut
17